How to configure Ethernet for luckfox pico board?

2024-07-22 9:53

Hello. I have a luckfox pico circuit. now i want to use rj45 port to access via ssh. i used unbutu image and wrote it to sdcard. then I soldered the txp, txn, rxp,rxn pins. I plugged the LAN port into the router and the signal light on the router is on but I checked the IP and it doesn't work. Is there any tutorial that can help me use Lan RJ45 port with this luckfox pico board. Thanks

2024-07-22 10:18

You need to modify the relevant device tree in the SDK yourself. Additionally, in terms of hardware, our version with an Ethernet port includes a transformer, which you can refer to in the relevant schematic diagrams.

https://wiki.luckfox.com/Luckfox-Pico/L ... evice-tree

2024-07-22 13:24

Luckfox Taylor wrote: ↑2024-07-22 10:18 You need to modify the relevant device tree in the SDK yourself. Additionally, in terms of hardware, our version with an Ethernet port includes a transformer, which you can refer to in the relevant schematic diagrams.

https://wiki.luckfox.com/Luckfox-Pico/L ... evice-tree
eth.png

Thank you for guidance. I apologize for not being much of an expert in electronics. Do you have any more specific illustrations?