Luckfox Forums

I have ordered a LuckFox Pico Pro Max 256mb, today i opened Rockchip Soc Toolkit and Installed Few Things In LuckFox! That i had installed previously in my LuckFox Pico Plus!

But On This LuckFox Pico Pro Max! After Installing! I Am Facing This Problem After Using The LuckFox Pico Pro Max Few Minutes!

Few minutes later! Device stoped blinking red light! Getting so hot in 10-20 Seconds, Soc Toolkit Doesn't Recognize The Device! But My Pc Says “ USB Device Didn't Recognized. ” I have Used 6 Different Pc/Laptop But Problem Didn't Solved! I have Used More Then 9 Different USB Cables! Nothing Changed!

It's Remaining So Hot, Red Light Doesn't Blink, And Soc Toolkit Doesn't Recognize!

I have Tried To Reset Button Didn't Worked!

I have Tried Boot Button More Then Many Times, Nothing Changed!



Please Kindly Someone Give me Any Way!

The device Is Not Damaged! Or Nothing Burned! Full Fresh Condition


Please Help

Hello, could you please try to provide the log information? If there is no output from the serial port, it's highly likely that the main controller RV1106 is damaged. You can contact the seller from whom you purchased the product to request after-sales service.

I have ordered this LuckFox Pico Pro Max From AliExpress And The Shipping took 30 days! I have contracted the seller but the seller said take this to any local mobile repair shop!


But i think this is not possible to repair by any mobile shop's!

Also The Seller Said! That The Product Will be fine after few minutes


What the heck

This forum is only for technical discussions. I am not responsible for warranty and after-sales processes. From a technical perspective, repairing it may require replacing the main controller, RV1106. Excessive heat and lack of TTY output are not normal conditions.

You can refer to https://wiki.luckfox.com/intro/ for further information and to contact after-sales support.