Luckfox Forums

Hi. I followed https://wiki.luckfox.com/Luckfox-Pico/L ... r-to-eth0/


I run this and the device is on the network:

INTERFACE="eth0" # Change this to your network interface (e.g., eth0, wlan0)
STATIC_IP="192.168.0.XX" # Change to your desired static IP address
NETMASK="255.255.255.0" # Change to your network mask
GATEWAY="192.168.0.XX" # Change to your gateway IP address
DNS_NAMESERVERS="8.8.8.8 8.8.4.4" # Change to your DNS server addresses

ifconfig "$INTERFACE" down
ifconfig "$INTERFACE" "$STATIC_IP" netmask "$NETMASK"
ifconfig "$INTERFACE" up
route add default gw "$GATEWAY" dev "$INTERFACE"

BUT after a few seconds it loses it's ip?

2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
link/ether XXXXX brd ff:ff:ff:ff:ff:ff

Hello, please make sure that udhcpc is not started in the background to get the IP. You can use the killall udhcpc command to shut down the udhcpc process