Page 1 of 1
請教Luckfox Pico Ultra W使用Luckfox-config設定spi
Posted: 2025-09-10 5:49
by JimmyCCH
各位大大，請教一下，我在使用luckfox-config要設定spi時，
做到最後/dev/下沒有出現spidev的裝置，
在設定的最後出現
GPIO1_C0 and SPI0_M0_CS0 cannot be enabled at the same time.
想請教這個要怎麼處理？
Re: 請教Luckfox Pico Ultra W使用Luckfox-config設定spi
Posted: 2025-09-11 10:45
by yangxj121
您好，这个原因是默认GPIO1_C0默认为复用为GPIO功能，建议您换成默认不是GPIO再做配置
Re: 請教Luckfox Pico Ultra W使用Luckfox-config設定spi
Posted: 2025-09-25 20:43
by fralloger
what is the correct way to do this?
Re: 請教Luckfox Pico Ultra W使用Luckfox-config設定spi
Posted: 2025-09-27 9:19
by yangxj121
Hello, configuration can be done through "luckfox-config". You can refer to
https://wiki.luckfox.com/Luckfox-Pico/L ... D%E7%BD%AE